text/microsoft-resx 2.0 System.Resources.ResXResourceReader, System.Windows.Forms, Version=4.0.0.0, Culture=neutral, PublicKeyToken=b77a5c561934e089 System.Resources.ResXResourceWriter, System.Windows.Forms, Version=4.0.0.0, Culture=neutral, PublicKeyToken=b77a5c561934e089 Added Assign Disable Enable Remove Assigned Battery Voltage Status Browse Cable Multiplier Capacity CHAN Channel Type Channel Summary Code DAS Channel DAS Channels DAS Serial DAS Summary EID EID Found EU Label HW SN Import Import File Done Failed Working Input Voltage Status JCode Mode Name NONE Polarity Post Trigger (sec) Pre Trigger (sec) Range Remaining Channels Requested Run Test Sample Rate (per sec) Sens Sensor SN Sensor SN Test Length (sec) Test Setup Name: Toyota Code Type Unassigned VAL (EU) VAL (%) Assign sensor? ID on the channel will be applied to the sensor and removed from any other sensors. User feedback required Current (amp) Delay (ms) Duration (ms) Limit duration Res. High Tol. (Ω) Res. Low Tol. (Ω) CH Add Code Delete Code Replace Filter TTS import requires either .csv or .xml input file TTS import requires a .csv filename in the OriginalImportFile attribute is an unexpected zero method type. Only None, AverageOverTime, and UsePreEventDiagnosticsZero are allowed J-Code {0} Required Channel(s), {1} System Sensor(s) Save File Search Test Name --- Analog Digital In TOM The sensor {0} has an EID, but no EID was found.\r\n\r\nPress OK to clear the EID for {0} and assign the sensor.\r\nPress Cancel to leave the EID unchanged and the sensor unassigned. ROI End (sec) ROI Start (sec) {0} is a duplicate Sensor Serial Number. {0} is a duplicate Channel Code. {0} is a duplicate Description. D In D Out ECM G5 Rack SPD SPS SPT Squib Total Units Sensor Assignment Error Hardware does not support {0} volt excitation. Devices at the following IP Addresses were unresponsive. Please reconnect or power cycle the units. Warning Non empty channel codes are required, please complete channel codes to continue Test Id [None] [Test Setup Name] [Time Stamp] Add DI Add Squib Requested SLICE AAF: {0} Requested TDAS AAF: {0} Sensor excitation {0} not supported by channel JCode {0} is a duplicate record {0} has an empty J-Code Reserved Sensor(s) found in file. These are now unsupported and were skipped. Sensor "{0}" not found in database