init

Common/DTS.Common/.svn/pristine/53/5320ccc4abe95a97c521d41a6786b12faaa06a6b.svn-base

@@ -0,0 +1,65 @@
+namespace DTS.Common.Interface.DASFactory.Diagnostics
+{
+    public interface IDiagnosticActions
+    {
+        /// <summary>
+        /// Which DAS Channel (CH# WRT entire DAS unit) are these diagnostic test 
+        /// instructions for?
+        /// </summary>
+        int DASChannelNumber { get; set; }
+
+        /// <summary>
+        /// Should we measure the excitation voltage being applied to this sensor?
+        /// </summary>
+        bool MeasureExcitation { get; set; }
+
+        /// <summary>
+        /// Should we measure the sensor's offset from 0?  (If measured, the returned offset can
+        /// be checked against the high and low offset limits that are properties of the 
+        /// AnalogInputDasChannel object corresponding to this sensor.)
+        /// </summary>
+        bool MeasureOffset { get; set; }
+        /// <summary>
+        /// should we check the open/closed/low/high nature of a digital input channel?
+        /// </summary>
+        bool CheckDigitalState { get; set; }
+
+        bool MeasureInternalOffset { get; set; }
+
+        /// <summary>
+        /// Should the firmware compensate for the offset from 0 of this sensor?
+        /// </summary>
+        bool RemoveOffset { get; set; }
+
+        /// <summary>
+        /// Should we measure the noise floor as a percentage of full scale readings?
+        /// </summary>
+        bool MeasureNoise { get; set; }
+
+        /// <summary>
+        /// Should an emulated shunt-check be performed on this sensor.
+        /// </summary>
+        bool PerformShuntCheck { get; set; }
+
+        /// <summary>
+        /// should run a squib fire check on channel
+        /// </summary>
+        bool SquibFireCheck { get; set; }
+
+        /// <summary>
+        /// perform a voltage insertion gain check (SLICE Pro)
+        /// </summary>
+        bool PerformVoltageInsertCheck { get; set; }
+        /// <summary>
+        /// Should a Calibration signal-check be performed on this sensor.
+        /// </summary>
+        bool PerformCalSignalCheck { get; set; }
+
+        /// <summary>
+        /// Should the resistance of the bridge be measured?
+        /// </summary>
+        bool MeasureBridgeResistance { get; set; }
+
+        bool AllActionsDisabled();
+    }
+}